Below are listed SOME of the accessories and replacement parts that we offer. We also offer OTHER accessories and replacement parts for our products, most of which are not listed but CAN be ordered.

Please contact us if you're looking for something you don't see below, click >  CONTACT US.

PARTS-INSUL KIT 01:   Antenna Insulation Kit      $15.00 USD + Shipping

Antenna insulation kit for our UHAM mounts and for your "other brand" or custom mounts.

This is the same antenna insulation kit that comes with the UHAM-100. Please see the downlinks page for the UHAM instruction manual if you need information on how to install this on your antenna. However, you may have other uses for this!!

This consists of EDPM rubber, 3/16" thick x 2" wide x 18" long, with five (5) tie strips for attaching the insulation to your antenna, mast, or whatever. The rubber is water proof and UV(sunlight) resistant. It is very flexible, easy to cut with scissors and works well to insulate your antenn from the V-clamp on the UHAM-100 mount. We have tested this at 100 watts on HF frequencies while "hosing water on the rubber", with excellent results. The tie strips are black, UV resistant and 14" long.

Our customers have used this with OTHER BRAND mounts to provide a better insulation of their antenna at the upper mounting point, compared to what the other brands provide. It has been tested on a Tarheel mount at 500+ watts: click > TEST RESULTS

To download the Installation manual click > INSUL KIT-01 MANUAL . To view the warranty click > WARRANTY

Product photos are shown below with dimensions. For more REP Design photos click > PRODUCT PHOTOS .  

The photo below shows what you get: 18 inches of 3/16 inch thick x 2 inches wide insulation with 5 tie strips (only need 2-4) - all UV resistant and waterproof.

The photo below shows the insulation installed on a 1.6 inch diameter motorized antenna.

** United States Customers: Shipping $5.00, shipping each additional $3.00 

PARTS_Coil-01              COST: $16.50 USD + Shipping

HF Load inductor coil and coil clip (comes with SHUNT100)

This is the same load inductor coil and clip that is used in our SHUNT-100. The coil is #14 tin plated solid copper and comes with a silver-plated coil clip with tightening screw. For those who don't need the weather-proof features of the SHUNT-100.

** United States Customers: Shipping $5.50 for one or multiple kits (same shipping for up to 10 kits).

PARTS_HD Lugs_1/4-3/8          COST: $8.50 USD + Shipping (5 pairs) 

5 pairs of HEAVY-duty screw solder lugs (comes with UHAM150)

These are HEAVY-DUTY solder screw lugs for 1/4 and 3/8 inch bolts that come with our UHAM-150 mount - five (5) PAIRS. These are heavier than what you buy at a typical automotive or hardware store.

** United States Customers: Shipping $3.00 for one set and $1.00 for each addition set.

WE'VE JUST ADDED NEW PARTS - check back soon as they will be added to our web site:

• 1/2" HD solder lugs - fit Hi Q Ant. ruggedized antennas with 1/2x20 stud (Hi Q does not include this)
• HD rust-proof and high quality SO239 nuts
• high quality single conductor jumper cable, 1.5 feet long, to go from an antenna base stud to a SO239 connector - includes Amphenol PL259 plug and your choice of HD solder lug (1/4  3/8 or 1/2") - made from Belden RG8 coax.